Emulsions and Drawing Oil
Euro Oil Tanzania Ltd, offers a wide range of Emulsions and Drawing Oil:
Emulsion for EC Aluminium drawing on thick-wire and medium-wire machines, as well as for manufacturing coated wire; working concentration is varied, depending on application, and ranges between 10% and 25%.
Wire drawing emulsion developed for drawing Aluminium wires of entry diameter of ca. 3.5 mm and final diameter 0.10 – 0.80 mm on single and multi-wire drawing machines with constant annealing process; working concentration is varied, depending on application, and it ranges between 10% and 25%.
Combines the advantages of mineral oil based and fully synthetic products. Ensures clean system, required in fine wire drawing (single- and multi-drawing) with the final diameter of 0.10 mm, as well as very long emulsion lifetime, excellent lubricating properties and long lifetime of drawing dies.
High performance product for thick-wire and medium-wire drawing machines as well as for mulitwire systems down to a final diameter of 0.20 mm, used for bare, tinplated and silverplated wire; working concentration of 5% -15 % enables very good lubrication combined with high cleaning efficiency of the wire and drawing system as well as long service life of the emulsion in use.
Designed for micro-drawing in multiwire systems down to final diameter of 0.05 mm; provides the highest cleanliness of the drawing system as well as extremely long service life of the solution.
Special product for cleaning wire after drawing and annealing process, as well as for spray and dip lubrication before spooling; after the medium evaporates, the product leaves a very thin, low-viscous film with good anticorrosion protection properties.
Water-miscible, semi-synthetic fluid for annealing at the working concentration between 0.5% and 2.0%; very good cleaning properties as well as anticorrosion and stains protection.
Universal product for thick-, medium-and fine-drawing (single- and multi-wire drawing machines) down to final diameter of 0.15 mm, for bare, zinc-plated and silver-plated copper.
Used as a non-diluted pasta for single drawing process after applying layers or lime coating, or during the final dry drawing stage as a soap solution for polishing.
Mineral oil free, emulsifying drawing oil concentrate for drawing bare and zinc-plated, as well as copper-plated and brass-plated steel wires.
Drawing oil with high viscosity and high chlorine content, water-immiscible; used for lubricating inside and outside parts of tubes, as well as for drawing rods and stainless-steel profiles.
Soft drawing paste, water-soluble, contains native esters and surface-active substances.
Water-immiscible oil for cold drawing of steel rods, with smooth and clear surface in wet drawing process.
Medium-viscosity oil for thick-wire and medium-wire drawing of Aluminium and its alloys; to be used in spraying machines.
Low-viscosity oil for thin-wire drawing of Aluminium and its alloys in single-and multiwire spraying drawing machines.
High-viscosity oil for thick-wire drawing of Aluminium and its alloys; recommended for dipping machines.
Chlorine-free, water-immiscible special oil for steel and stainless steel thin-wire and micro-wire drawing.
Oil for drawing medium and small-size wire; ensures long service life of drawing capstans.
